Wing Mait Free trial

WARDOGS BUILD MODULE

Roof Parapet

Raise the roof, ring it with walls, leave one angled gap you cannot be shot through.

VERIFY AGAINST THE LIVE BUILD WHEELSOURCE-DERIVED PLAN
Schematic diagram for the Roof Parapet module

Module at a glance

Hammer tier
Not stated. The source video does not state a hammer tier for this module.
Footprint
four existing roof blocks raised one level, plus 12 brimmer walls ringing the roofderived from source counts
Materials
  • Small Hesco Block: x4derived
  • Brimmer Wall: x12derived
Counters
  • being shot through the gap
Weak to
Not stated by source.

Build steps

  1. Step 1 Small Hesco Block (x4)

    Small hesco blocks. Raise all four roof blocks one higher.

    These are the four existing blocks on the tower roof.

    OCR watch: label "Hesco Block", completion true

  2. Step 2 Brimmer Wall (x4)

    Four brimmer walls above the entrance. Flat side in.

    Sits directly over the airlock entrance below.

    OCR watch: label "Brimmer Wall", completion true

  3. Step 3 Brimmer Wall (x3)

    Three brimmer walls, jump-up side. Flat out, leave a gap.

    The gap sits between the hesco block and the wall.

    OCR watch: label "Brimmer Wall", completion true

  4. Step 4 Brimmer Wall (x2)

    Two brimmer walls, opposite side. Flat out, leave a gap.

    Mirrors the jump-up side.

    OCR watch: label "Brimmer Wall", completion true

  5. Step 5 Brimmer Wall (x3)

    Remaining three walls, flat side in. Close it off.

    The gap is your firing and access port; the angle keeps you from being shot through it.

    OCR watch: label "Brimmer Wall", completion true

Part of the Anti-Air FOB blueprint.

Build plan derived from a video by IIEKKO, "The Ultimate Anti-Air FOB in Wardogs!".

Wing Mait is an independent project, not affiliated with or endorsed by WARDOGS or its publisher.