Wing Mait Free trial

WARDOGS BUILD MODULE

Build the outer stand-off ring

The outer layer is deliberately separated from the main wall so vehicles cannot drive directly onto the structure or use it as a climb point.

VERIFY AGAINST THE LIVE BUILD WHEELSOURCE-DERIVED PLAN
Schematic diagram for the Stand-off Perimeter module

Module at a glance

Hammer tier
Not stated. The source video does not state a hammer tier for this module.
Footprint
Hedgehog ring set away from the walls with barbed wire outside it
Materials
  • Hedgehog: quantity not stated
  • Barbed Wire: quantity not stated
Counters
  • vehicles reaching or climbing the wall
  • infantry crossing the outer approach
Weak to
Not stated by source.

Build steps

  1. Step 1 Hedgehog (quantity not stated) label unconfirmed

    Hedgehogs out from the wall.

    Leave stand-off distance between the shell and the hedgehog ring. The source does not specify a measured distance.

    OCR watch: label "Hedgehog", completion true This wheel label is our best reading, not confirmed against the source.

  2. Step 2 Barbed Wire (quantity not stated) label unconfirmed

    Wire outside the hedgehogs.

    Place barbed wire outside the vehicle barrier to slow infantry before they reach the main structure.

    OCR watch: label "Barbed Wire", completion true This wheel label is our best reading, not confirmed against the source.

Part of the Layered Indirect FOB blueprint.

Build plan derived from a video by HitboTC, "I Built an INDESTRUCTIBLE Base (WARDOGS)".

Wing Mait is an independent project, not affiliated with or endorsed by WARDOGS or its publisher.